| Page | 01 |
|---|
| Article | Description / Summary |
|---|---|
| UAP1080 | Abattoir Carcass Rate Controller What This Application Does Input = potentiometer (0-5k Ohm). Scale is 4-10 Carcass/minute. Scale adjustable via Access Module AM702. Output = 0-20mA. Relay output = ON/OFF ON TIME is 1 second (adjustable via a constant. Min = 0.02 sec). OFF ... |
| UAP0038 | Control Unwind Paper Speed Using Dancing Arm The project is to automatic the speed control of a paper roll feed into a cutting machine. The roll stand is driven be the main cutting machine but has its own speed control. The speed is detected by a dancer arm that if it is at the correct ... |
| UAP1076 | Engine Speed Controller The desired flow rate is 1040 cubic meters per hour. The flow meter output is 4-20mA represents 0-2000 cubic meters per hour. The engine governor is controlled by a Linak LA12 actuator, which gives an RPM range from 790 to 1760 under load. ... |
| UAP1096 | Shaft Speed with Forward and Reverse Tables Description The equation to provides one look-up table for FORWARD linearization and one look-up table for REVERSE linearization. Input: 2 x 24V pulses, quadrature Range: 0-400Hz Output: 0-10Vdc isolated Relay : RLY1 closes on forward direction ... |
| UAP0018 | Speed Control of 4 Gear Motors Operating Description A master 4 to 20mA signal is fed into a USC to set the required speed rate from 0 to 100% The USC will measure the speed of the motor via a proximity sensor on the output shaft. The speed range on the output shaft is 0 ... |