| Page | 01 |
|---|
| Article | Description / Summary |
|---|---|
| HLP1073 | a- Using The PID Wizard < a > b USC Config 106 contains a wizard to create programs for the USC701. These programs are easy to make and enable technicians with no programming experience to create a large variety of signal conditioning modules from just ... |
| UAP0038 | Control Unwind Paper Speed Using Dancing Arm The project is to automatic the speed control of a paper roll feed into a cutting machine. The roll stand is driven be the main cutting machine but has its own speed control. The speed is detected by a dancer arm that if it is at the correct ... |
| UAP1076 | Engine Speed Controller The desired flow rate is 1040 cubic meters per hour. The flow meter output is 4-20mA represents 0-2000 cubic meters per hour. The engine governor is controlled by a Linak LA12 actuator, which gives an RPM range from 790 to 1760 under load. ... |
| UAP1078 | Heating Control PID PWM Two Sensors CH1 Measured room temperature degC. A customised lookup table is used to suit the customers existing sensors CH2 Measured outside temperature degC. A customised lookup table is used to suit the customers existing sensors. Con_d SetPoint is ... |
| UAP0026 | Input follow + Offset + PID + Auto/Manual hot keys This application is a backup PID controller and operates in two modes of operation. Auto Mode The ACCESS module displays pressure measured byCH1 in auto mode. The mA signal going to valve 1 is measured (CH2) and retransmitted to value 2 with ... |
| UAP0025 | PID Control plus Ziegler Nichols tuning Method This application contains a standard PID algorithm that can be used to control any number of devices. The USC can be programmed to accept an input signal, condition it, compare it to a set point signal and produce a corrective output signal. ... |
| UAP0040 | PID Control with External Set Point and Hotkeys The PID algorithm is now incorporated within the new module This article has been written for issue d where the PWM output is cooling to control temperature. The Ziegler Nichols Tuning Method The Standard Program Details USC PID Application ... |
| UAP1074 | PID Controller With Batch Timer When power is applied to the module the output is set to 4mA and the dosing is stoped. The operator must press ENTER on the access module then CONSTANTS and enter the required FlowRate between 0 and 6, decimal input is used. The access module ... |
| UAP1072 | PID Controller With Input Filter on P1 This application controlled flow by measuring frequency from a flow sensor, as there was a large amount of turbulence in the pipe large variations in flow were displayed. This problem was attacked in two ways; Ensure that fluctuations in the ... |
| UAP1085 | Sand Flow Controller A sand/water slurry is pumped through a pipe mounted on pontoons. An Ultrasonic Sensor calculates the percentage of sand in the slurry by measuring the height of the pipe above the water surface. The pontoon will sink deeper for higher sand/water ... |